One of the most popular rooms in our house is our small office. Here I do most of the work related to blogs, but my favorite is that it allows me to look down and have some problems with the environment around me.
More importantly, in the last few months I have been shockingly shocked – everyone thinks that their house has isolated insulation (walls insulation). Last week there were at least 7 houses left!
Nevertheless, he will say thank you for isolating your house, I heard that you are shouting?
Read more: Opzoek naar spouwmuurisolatie?
Consider everything, yes and no.
We have an isolated last part of our house – under the floor, space, funnel, etc. We finished it, but some areas of your house’s isolated (isolated) are a terrible idea that will cause serious problems later problem. One of the problem areas is the restoration of insulation.
In this case, what is insulation (wall insulation)?
Modified insulating insulation (cavity wall insulation) is basically a protective material that is inserted into the holes between the outer and inner brick layers of the outer muir (wall). Filling with hol material with a constant gap (insulating) is designed to reduce the energy loss through muur.
How it works?
The organization that performed the work (which in fact did not work for DIY) appeared on a large truck. Within a few hours they penetrated a large gap into the outer layer of the brickwork and presented a large number of small balls of polystyrene (which are in fact called EPS balls) into the cavity between them (cavity)) c. Two brick layers. At this point they fill the gaps of your muir and close again.
So, why is there no isolated insulation (wall insulation)?
Considering all, this is fair. Filling the cavity (cavity) between the brickwork, you will certainly pass between the outer and inner layers, and hol (cavity) is purposeful! It establishes a boundary between heat (indoors) and coolness (outdoor temperature) in your home and between wet and dry outdoor lighting.
If water gets into the hole, it will destroy the outer layer of the brickwork and dry up (so a brick is needed for the air). If you have the ability to modify the erosion, dilution should pass through an impermeable barrier (insulated) and from below. This is the idea.
Usually, especially if the place in which you live is as wet as we are, it is impossible to imagine in normal conditions. If it is wet and windy, the introduction of rain can not allow the time (cavities) to dry, so moisture can be replaced by an inner wall and a wall.
Thus, the installer is essentially visually weakened when filling the cavity (cavity). Indeed, it penetrates many gaps and goes directly to the protective ball until it looks like the floor, but it can not be completely filled with pockets that you can leave unprotected in your mure!
This not only does not prevent you from warming up, but also creates warm forests, which are mostly helpless protection, allowing you to meet the hot and cold air. The large temperature contrast created by the stent will lead to accumulation, and along these lines can also cause problems with humidity.
In general, this is something that I will not do – forever, especially if (like us) you have a pit 5 cm wide – do not do it!
Obviously, this does not mean that the innovation will not change in the future, but now it is reasonable no matter what harm to us.
I would even say that I would prefer not to buy a house with a modified insulation (hollow wall insulation). I understand that this sounds very special, especially when you think about our house when we get a room, but for us it’s too dangerous and too much trouble, so it’s working incorrectly.
Imagine a scene where I just changed the isolation.
If you have just installed a modified insulation, you can use an infrared camera to give an overview of your home. This will allow you to check whether the protection in the distributor is uniform, and in any case allows you to decide if there are fill holes in order to avoid problems with the thermal crossover. We will additionally check your instructions and gullies to make sure that everything is in good condition, along these lines is ideal from any penetration of moisture, which, according to many people, is possible.
If you experience problems with isolation or perhaps need advice, you can check the spouwmuur blur.
Obviously, this is not the case when there is an isolated isolation in each house (hollow wall insulation), you may not have a problem, but if you decide to introduce defensive protection and begin to collide with the accumulation, Explain that we did not remind you! Be careful and do your research!
Do you have spouwmuur isolatie (wall warming)? We would like to know if you are doing this, if you are satisfied or have any problems!